At ordinary times, our common roads are cement roads and asphalt roads. What are the differences between the cold recycling machine in maintaining these two kinds of roads?

1、水泥冷再生

1. Cement cold recycling

水泥冷再生充分利用廢舊材料，并按比例加入一定量的添加劑在自然環(huán)境溫度下就地連續(xù)地完成材料的銑刨、破碎、拌合、攤鋪及壓實成型，冷再生租賃從而修筑出具有所需性能質量的新基層。

The cold recycling of cement makes full use of waste materials, adds a certain amount of additives in proportion, and continuously completes the milling, crushing, mixing, paving and compaction of materials at the natural ambient temperature, so as to build a new base with required performance and quality.

與傳統(tǒng)施工方法相比，水泥冷再生成本低、效率高、質量好，可減少污染。

Compared with traditional construction methods, cement cold regeneration has the advantages of low cost, high efficiency and good quality, which can reduce pollution.

2、瀝青冷再生

2. Asphalt cold regeneration

瀝青路面冷再生將舊路銑刨、剝離所得的回收瀝青路面材料，經破碎篩分，抽提測定油石比、礦料級配組成及回收瀝青的性能指標后，按新的瀝青再生混合料配合比設計，適當加入部分新骨料、水、乳化瀝青等，在常溫條件下（不加熱）拌制新的瀝青路面材料。冷再生技術可以降低成本10-20%左右，且生產效率非常高。

Cold recycling of asphalt pavement: the recycled asphalt pavement materials obtained from milling and stripping of the old road are crushed and screened, extracted and determined to determine the asphalt aggregate ratio, mineral aggregate gradation composition and performance indexes of the recycled asphalt. According to the mix proportion design of the new asphalt recycled mixture, some new aggregate, water and emulsified asphalt are appropriately added to mix the new asphalt pavement materials under normal temperature (without heating). Cold regeneration technology can reduce the cost by about 10-20%, and the production efficiency is very high.